How To Pair A 2gig Hd 100 Camera To A Hub

The 2GIG HD100 Camera can connect to the network using WIFI setup via WPS, WIFI setup through the Alarm.com customer website, or with a wired Ethernet connection. In one case the photographic camera is connected to the network, it tin exist configured to work with Alarm.com remotely through the customer'south website.

Setting up the 2GIG HD100 camera involves two separate deportment. First, the camera must be continued to the customer'due south network. This tin can be accomplished in a number of unlike means. The first of which is via WIFI through WPS.

If your router supports WPS, follow these steps:

one. Begin WPS pairing. With a router that supports WPS (WIFI protected setup), press the WPS push on the router until information technology goes into its WPS pairing procedure. This procedure may differ per router. Read the instructions for your router to complete this step successfully.

ii. Pair the camera. Press the WPS button on the back of the camera. The photographic camera will brainstorm pairing with the router. While in WPS pairing mode, the camera will brandish a blinking Yellow LED. Do not bear on the camera while in this mode. A successful pairing will be indicated by a solid Greenish LED.

If your router does non support WPS, and you lot still wish to utilise the camera with a WIFI connection, follow these steps:

1. Connect via Ethernet. Temporarily connect the camera to the router with an Ethernet cable.

2. Configure using Alarm.com. Use your Warning.com credentials to log into the Alarm.com customer website: www.alarm.com/login

A annotation almost the MAC address on the 2GIG HD100: In that location are ii MAC addresses printed on the back of the photographic camera. One marked ETH, and some other marked WIFI. Alarm.com uses the ETH MAC when the camera communicates with the client website regardless of how the camera is continued to the network.

If you need to look in your router's client list to discover the camera, it will show the ETH MAC when the camera is connected to the network via an Ethernet cable. It will display the WIFI MAC if the photographic camera is continued to the network via WIFI.

Once you have logged into Alarm.com, go to Video, and so Settings, and click on "Add Video Device". The device you use to login to Warning.com and the HD100 camera should both be continued to the same network for the photographic camera to exist found.

The 2GIG HD100 will not show upward automatically. You will demand to search for it:

In one case the camera has been located, requite it a name. So click Install:

In one case the initial install has been completed, if you want to set the HD100 up on a WIFI network, select "Set Up Wireless Now":

Choose "Scan for Networks" to accept the photographic camera automatically search for your WIFI network's SSID. If your network is set non to broadcast the SSID, you may need to select "Set Upward Manually". These steps assume the SSID is being broadcast. The HD100 requires a 2.4 GHz network connection:

Subsequently Scanning for networks, a list of bachelor networks will be shown. Choose the correct network. Then click "Next":

From this point, follow the on-screen prompts to enter the password and bring together the WIFI network. When prompted, remove power cable and ethernet cable. And then re-apply power, and press "Adjacent":